Vicor VI Chip High Voltage BCM Customer Evaluation Board User Manual

Browse online or download User Manual for Hardware Vicor VI Chip High Voltage BCM Customer Evaluation Board. Vicor VI Chip High Voltage BCM Customer Evaluation Board User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
UG:010 vicorpower.com Applications Engineering: 800 927.9474 Page 1
Features
Oscilloscope probe jack for output voltage
a
nd ripple measurements
Simple to use
Ring lug or solder connections
Introduction
WARNING: The High Voltage BCM
®
Customer Evaluation Board contains exposed
metal carrying lethal voltages when under power. Care should be taken to protect the
user from accidental contact when under power.
The BCM
®
Evaluation Board offers a convenient means to evaluate the performance of
Vicor’s BCM bus converter and has been optimized for user convenience. Refer to the appropriate
data sheet for performance and operating limits. Data sheets are available
at
www.vicorpower.com/dc-dc-converters-board-mount/bus-converter-module.
It is important to remember the fast response of most BCM modules can readily show the
limitations of the source, load, and associated wiring connected to the evaluation board.
Care should be exercised to minimize stray source and load impedances in order to fully
exercise the module.
Please refer to Figure 1 for locations of the input and output connections as viewed from the
component side. Wires may be soldered directly to the pads instead of ring lugs if desired to
minimize circuit impedances.
VI Chip
®
High Voltage BCM
®
Customer Evaluation Board
Contents Page
Features &
Introduction 1
Important
Information 2
Set Up 3
Recommended
Hardware 4
Thermal
Considerations 4
TM
RSV
PC
+IN
–IN
C
L
2.52
64,0
Ø 0.20 Typ
5.08
1.65
41.9
+OUT
– OUT
C1
BCM
TM
Bus Converter
J1
TP1
TP2
TP7
TP4
TP6
TP5
Figure 1
BCM
TM
Customer Evaluation Board
layout and dimensional drawing,
component side.
USER GUIDE | UG:010
Page view 0
1 2 3 4

Summary of Contents

Page 1 - Customer Evaluation Board

UG:010 vicorpower.com Applications Engineering: 800 927.9474 Page 1Features• Oscilloscope probe jack for output voltage and ripple measurements• Simp

Page 2 - Evaluation Board schematic

UG:010 vicorpower.com Applications Engineering: 800 927.9474 Page 2Using the High Voltage BCMTMEvaluation BoardImportant InformationWARNING: Hazardou

Page 3

UG:010 vicorpower.com Applications Engineering: 800 927.9474 Page 3Set UpThe High Voltage BCM®Evaluation Board should be set up as follows:Note: Care

Page 4 - Thermal Considerations

vicorpower.com Applications Engineering: 800 927.9474 Rev 1.0 Page 412/2013Primary Control (PC)The PC can be used to disable the BCM®module, monitor

Comments to this Manuals

No comments